|
Post by dobridiv on Mar 10, 2011 15:38:19 GMT -5
I have Farfisa FAST4 organ Last owner sold it to me with all wires that goes to output and pedal jack disconnected and unsoldered... Now I have problem to back them and solder them to a proper places ....actually jacks pins.... Can someone help about this: on the picture you can see wires and jacks down there in chasis.. Second problem is to low output signal ....when i plug red wire to an external amplifier I have to set volume on maximum to hear sound which is so thin... I found that one filter cap in power supply is bad .... can you tell me is it 2000uf ...30v.... marks on it are old..... and I can see blurred F near u letter and number 2000..... it is 2000 uF ...correct? other marking says Vl 30....I suppose it is 30 volts but I do not understand last stamp that says Vi 45...what it means? What will be good replacement for this cap? here is the picture: thanks a lot Alex
|
|
|
Post by joelindsey on May 12, 2011 8:18:48 GMT -5
I'll be picking up a Fast 4 of my own pretty soon, so when I do I'll let you know about the wires.
As regards the cap, it is a 2000uf, 30 Volt. Any 2000uf cap that is at least 30V will work fine. Just make sure you get the polarity correct when you replace it. Replacing all the electrolytic capacitors in the organ would be a good idea. Even if they don't look bad, they most likely are. The chemicals in those caps dry out after a decade or two. I replaced all the electrolytics in my Rheem and it solved several issues with the organ.
|
|